Kitronik Inventor’s Kit for BBC micro:bit (French Edition) (micro:bit not included)

The BBC micro: bit inventor’s kit provides a fantastic way to learn how to build and control electronic circuits. The BBC micro: bit has a selection of pins that are located on the bottom edge of its PCB (see datasheet below for details). Using our specially designed Edge connector board for the micro: bit BBC in conjunction with the test board (see below), it is easy to use these pins to connect additional components to the micro: bit BBC.

No soldering is required and you can build your first circuit in minutes!

Note: This kit requires assembly.

Features:

No soldering required – build your first circuit in minutes!
Complete 10 experiments included in the included step-by-step tutorial book.
All parts are included to conduct the 10 experiments (listed below).
Cut out 21 accessible pins from the micro: bit BBC using the Edge Connector board for the micro: bit BBC (included).
Small prototype breadboard included for rapid prototyping.

Contents:

• 1 x mounting plate.
• 1 x Potentiometer and Finger Adjustment Spindle.
• 2 x 10mm plastic spacer.
• 1 x sticky battery holder.
• 1 x small prototype drawing board.
• 1 x terminal connector.
• 4 x push switch.
• 1 x motor.
• 1 x transistor.
• 2 x 5mm red LED.
• 2 x 5mm orange LED.
• 2 x 5mm yellow LED.
• 2 x 5mm green LED.
• 1 x RGB LED 5mm.
• 1 x fan blade.
• 5 x 2.2KΩ resistor.
• 5 x 10KΩ resistor.
• 5 x 47Ω resistor.
• 1 x Edge connector bypass board for BBC micro: bit.
• 1 x miniature LDR.
• 10 x male to male jumper wires.
• 10 x male to female jumper wires.
• Electrolytic capacitor 1 x 470uF.
• 1 x Piezo Element Buzzer.
• 4 x M3 pan head screws.