The BBC micro: bit inventor’s kit provides a fantastic way to learn how to build and control electronic circuits. The BBC micro: bit has a selection of pins that are located on the bottom edge of its PCB (see datasheet below for details). Using our specially designed Edge connector board for the micro: bit BBC in conjunction with the test board (see below), it is easy to use these pins to connect additional components to the micro: bit BBC.
No soldering is required and you can build your first circuit in minutes!
Note: micro:bit card NOT INCLUDED
Note: This kit requires assembly.
Features:
No soldering required – build your first circuit in minutes!
Complete 10 experiments included in the included step-by-step tutorial book.
All parts are included to conduct the 10 experiments (listed below).
Cut out 21 accessible pins from the micro: bit BBC using the Edge Connector board for the micro: bit BBC (included).
Small prototype breadboard included for rapid prototyping.
Contents:
- 1 x mounting plate.
- 1 x Potentiometer and Finger Adjustment Spindle.
- 2 x 10mm plastic spacer.
- 1 x sticky battery holder.
- 1 x small prototype drawing board.
- 1 x terminal connector.
- 4 x push switch.
- 1 x motor.
- 1 x transistor.
- 2 x 5mm red LED.
- 2 x 5mm orange LED.
- 2 x 5mm yellow LED.
- 2 x 5mm green LED.
- 1 x RGB LED 5mm.
- 1 x fan blade.
- 5 x 2.2KΩ resistor.
- 5 x 10KΩ resistor.
- 5 x 47Ω resistor.
- 1 x Edge connector bypass board for BBC micro: bit.
- 1 x miniature LDR.
- 10 x male to male jumper wires.
- 10 x male to female jumper wires.
- Electrolytic capacitor 1 x 470uF.
- 1 x Piezo Element Buzzer.
- 4 x M3 pan head screws.